Alpha ECG-125 Manuál s instrukcemi stáhnout pdf (Strana 45)

3. Place the grinding wheel on top of the adjust screw and check the air gap between

the top of the grinding wheel and the brush assembly. The grinding wheel should

be adjusted so there is a 1mm air gap between the ruler and the brush ring. Test by

turningthewheeltomakesuretherulerisoatingontopofthebrush.

4. Iftheairgapistoolargeortoosmallremovetheangeandadjustscrew.Turnthe

adjust nut clockwise to raise the height of the grinding wheel or counter clockwise

to lower. Go back to step three and check the air gap again. Repeat until air gap is

correct.

Note: You will need to check the grinding wheel height before each use. As the diamond

segmentsonthegrindingwheelweardown,themanualheightadjustmentange

will need to be adjusted to keep the diamond segments just above (1mm air gap)

the top of the brush assembly.

Figure-44

Figure-45

Setting the Air Gap on the Manual Height Adjustment Flange

Adjusting the Manual Height Adjustment Flange

Hold the Adjust

Screw and locking

Nut in place

Turn Adjust Nut

to raise or lower

the height of the

grinding wheel

Air Gap

1 2 ... 40 41 42 43 44 45 46 47 48

Žádné komentáře

Alpha ECG-125 Manuál s instrukcemi Strana 45